rjensen
11/28/2006 11:22:29 PM
I will be receiving my Hypertech Programmer in a few days and was wondering if anyone knows what I should input for the rev limiters and shifting points. I have an '04 C5, auto tranny, with a full system/cat-back exhaust system. I understand Hypertech makes some suggestions in their instructions, but was wondering if anyone who has alreay done this to their vette can make some suggestions. All help will be greatly appreciated. Thanks in advance.
Take care, stay safe.
RJ
Lee Willis
11/29/2006 4:47:09 PM
Leave the rev limiter set to what it was from the factory. It is mainly set based on valve float likelihood so I would not take a chance and raise it. As to shift points, I'd go with what hypertech advises.
rjensen
11/30/2006 12:38:55 PM
quote:
ORIGINAL: Lee Willis
Leave the rev limiter set to what it was from the factory. It is mainly set based on valve float likelihood so I would not take a chance and raise it. As to shift points, I'd go with what hypertech advises.
Thank you for taking the time to reply. I will be sure to follow your advice.
