RE: Ignition system woes help needed

Printable Version

Corvette >> Corvette Models >> Corvette C3 Forum >> RE: Ignition system woes help needed

Page: <<   < prev  1 [2] 3 4   next >   >>

Login Message << Older Topic   Newer Topic >>

RE: Ignition system woes help needed - 1/9/2008 7:10:06 PM    Rickcusaf   Posts: 172 Joined: 8/26/2007 Status: offline Thanks guys =) Like I said if anyone is ever in west florida and needs a place to crash I've got an extra bedroom.  Guess I'll rma the distrib and hope that's the problem =) Any ideas what would be causing the ignition coil to overheat? I'm siding more with the messed up distrib, but wanted to make sure I don't actually have two problems and am missing one. (in reply to blueshark) Post #: 11

RE: Ignition system woes help needed - 1/9/2008 7:32:25 PM    73shark Posts: 1089 Joined: 4/18/2006 Status: offline One thing that would cause the coil to get hot is if it had a constant 12 volts applied from the distributor (or 8 volts in the run mode) _____________________________ So many toys, so little time (in reply to Rickcusaf) Post #: 12

RE: Ignition system woes help needed - 1/9/2008 9:22:04 PM    Wedge Posts: 223 Joined: 11/3/2005 Status: offline Rick, Have you disconnected the lead from the coil to the dist and grounded it to see if you get spark from the coil?  If you get a spark, your problem is the dist.  Just make sure you aren't standing in a puddle... Blaster coils do get warm, but should not be hot to the touch. Like Shark points out, there might be a 12v constant short that is also energizing your coil and causing your battery to drain. Do you have 12v at the coil input with the key off?  As far as actually seeing damage inside the dist cap from a reverse polarity short would be pretty rare unless more than 12v hit it.  The pickup is really sensitive to polarity... one way only... ;) Later, Wedge (in reply to 73shark) Post #: 13

RE: Ignition system woes help needed - 1/9/2008 11:59:26 PM    Rickcusaf   Posts: 172 Joined: 8/26/2007 Status: offline Hmm, I have not tried that yet. I'll test it first thing tommorow morning. =) Once again thanks for all the great advice everyone. (in reply to Wedge) Post #: 14

RE: Ignition system woes help needed - 1/10/2008 4:07:35 PM    Texas Jim   Posts: 441 Joined: 12/15/2005 Status: offline I was in the Military and the people who ship household goods and vehicles do some stupid things.  Make sure that you stick it to them good.  Make them buy you a whole new set-up and pay you for the time you spent, all of it, working on it.  Get everything new and start from scratch.  Tell them that they can have the entire old set-up.  Since they screwed with your car, you can get just what you want as they have no business messing with your car in that way.  It's a 'Vette with a special ignition system that they should have taken care not to screw up.  I'd stick it to them.  You CAN get it. (in reply to Rickcusaf) Post #: 15

RE: Ignition system woes help needed - 1/10/2008 5:54:58 PM    78buckshot   Posts: 653 Joined: 1/28/2007 From: Michigan Status: offline Hi Rick, the ignition coil is probably still OK. You wont get spark at the high side of the coil with a constant 12 volts applied to the low voltage terminals. The 12 volt input needs to make and break in order to cause the coil to spark, sounds like the distributor module or pickup coil is fried. (in reply to Texas Jim) Post #: 16

RE: Ignition system woes help needed - 1/13/2008 9:03:10 AM    Wedge Posts: 223 Joined: 11/3/2005 Status: offline Hey Rick... Just re-read that post that I wrote... boy, my head had to be up my backside at least 3'. Sorry!  I forgot my flow... pickup mod controls spark impulse... if the mod is bad, and I still feel that is the problem... no pulse to the coil.  Hope my troubleshooting folly didn't cause you to waste any time. I think I was a little distracted packing for a 4 day heli ski trip in Canada... even forgot my goggles... Wedge (in reply to 78buckshot) Post #: 17

RE: Ignition system woes help needed - 1/13/2008 10:01:22 AM    Rickcusaf   Posts: 172 Joined: 8/26/2007 Status: offline No worries =) Hope your ski trip was a blast. I've always wanted to take a heli up a mountain and ski back down.  (in reply to Wedge) Post #: 18

RE: Ignition system woes help needed - 1/14/2008 8:52:52 PM    Rickcusaf   Posts: 172 Joined: 8/26/2007 Status: offline I think I'm losing my mind. I found and repaired the fusible link. (The previous bubba had used a quick connect instead of a fusible and wrapped it in electrical tape..) I also bought a new HEI distributor/cap/coil. I wired everything and put the firing order in. Still no spark. What could be causing this? I advanced the timing a bit by rotating the distributor clockwise and I think I'm starting to go crazy. (in reply to Rickcusaf) Post #: 19

RE: Ignition system woes help needed - 1/14/2008 9:57:28 PM    pg Posts: 1038 Joined: 8/7/2006 Status: offline Where was the fusible link that was "bubbaed" up? And did you check all the connections as dv8 suggested? PG. (in reply to Rickcusaf) Post #: 20

Today's Posts
Most Active Topics
Make A Donation
Forum Rules & FAQ
RSS Feeds

Corvette Prices

Corvette
Corvette Z06
Corvette History

Top 10 Posters
c3 starship 4749 blueshark 2168 topspeed 2092 lee willis 1947 mech259 1758 pay2play 1533 cwb 1506 corvette kin 1162 73shark 1089 pg 1038

New Vendors
Corvette Guys
AMSOIL - Performance Oil Technology
Royal Purple