Fuse box labeling

Corvette Forums Corvette Classifieds Gallery Corvette News Member List Search Sponsors
Forum FAQ Calendars Contact Us Corvette Recalls TSBs Corvette Timeslips Register Login

Fuse box labeling

Printable Version

Corvette >> Corvette Models >> Corvette C3 Forum >> Fuse box labeling

Page: [1]

Message

<< Older Topic Newer Topic >>

Fuse box labeling - 3/26/2008 2:12:25 PM

79cvette

Posts: 11
Joined: 6/25/2007
Status: offline

Hey guy's, I have 1979 corvette. I have 20 amp fuse that blows the minute you put it in.
I can read the box anymore to see what it is for. The fuse is power all the time. So not sure where to start looking.
What I need is to find a labeling for it.
Thanks

Post #: 1

RE: Fuse box labeling - 3/26/2008 3:41:31 PM

wrwalke

Posts: 391
Joined: 11/1/2005
Status: offline

Not sure if a 79 is anything like my 81, but...

http://www.thebunker.com/panel-81.jpg

bill.

(in reply to 79cvette)

Post #: 2

RE: Fuse box labeling - 3/26/2008 4:57:42 PM

78buckshot

Posts: 671
Joined: 1/28/2007
From: Michigan
Status: offline

I have a '78 wiring diagram. 25A-heater & A/C, 20A-turn sig & back-up, 20A-throttle solenoid, 25A-wiper, 20A-ctsy, cig ltr,& clock,anti-theft,dome, 20A-tail, side,under hood, 20A- stop, haz, key buzzer, 20A-radio & rear defog. Hope this helps, it's a combination my diagram and '78 owners manual.

(in reply to wrwalke)

Post #: 3

RE: Fuse box labeling - 3/26/2008 8:21:07 PM

73shark

Posts: 1129
Joined: 4/18/2006
Status: online

Can you tell what things aren't working?

_____________________________

So many toys, so little time

(in reply to 79cvette)

Post #: 4

RE: Fuse box labeling - 3/27/2008 8:00:13 AM

79cvette

Posts: 11
Joined: 6/25/2007
Status: offline

Hey guy's thanks for the info. The info Mr Bill sent looks like it is the CTSY CLK fuse. That makes good sence to me. I did have a few thing not working, But was able to get all that repaired. Except for the Power Antenna. I disconnected the relay to it and that didn't fix the short.I had the center console removed and reinstalled with all new screws. There where no screw behind it before. So I put some in there. The console is much tighter...And that is where the clock is also. So I might be grounding out behind there...So I will take it down over the weekend and see.Wish me luck. If not I will be back.Thanks again for your help

(in reply to 73shark)

Post #: 5