alive69
Posts: 54
Joined: 10/8/2006
Status: offline
|
Since many of you looked in and had no answers and since I finally figured it out myself, I will list the answers and hope it helps someone down the line. 1st. There are 4 wires not 2. There are 2 light blue wires and 2 yellow wires. These are connected to a double, hard plastic, female, slip on connector and the connector fits the 2 male posts on the wiper door solenoid. 2nd. The light blue wire starts at the wiper switch, runs to the solenoid then into a large loom that runs to a positive battery source. The yellow wire starts at the relay located near the actuator canister, runs to the solenoid and then into a large loom which goes to a negetive ground. If this circuit is compromised the wipers will not function properly. Thanks for looking in.
|
Printable Version
Wiring question - 
