Corvette Forums   2006 Corvette C6 Z06 2006 Corvette C6 Z06  
Corvette Forums
Corvette Forums   Corvette Classifieds   Gallery   Corvette News   Member List   Search   Sponsors
  Forum FAQ   Calendars   Contact Us   Corvette Recalls   TSBs   Corvette Timeslips   Register   Login


81 VETTE AND CRATE MOTOR

  Printable Version
Corvette Forums >> General >> General Tech >> 81 VETTE AND CRATE MOTOR Page: [1]
Login
Message << Older Topic   Newer Topic >>
81 VETTE AND CRATE MOTOR - 3/29/2006 5:23:19 PM   
Zurok

 

Posts: 14
Joined: 1/3/2006
Status: offline
Gents, Hope all is well. I am looking at buying an 81 vette all stock at about $9K. I wanted to install a ZZ4 crate motor in it to have a good looking vette with a new engine and good performance. Here is the link to the crate motor.
ZZ4 Crate Motor
I only wanted to buy the crate motor and stuff it in. Are there upgrades you recommend I get with it? cam? intake? carb? i have about $5K to spend on the motor. My intent is to drive it on weekends and open it up once in a while. Also, will this bolt right up to the stock3spd auto tranny? will the accessories and pullies bolt directly on? I intend to call the engine builder and ask these questions but wanted a second opinion.


_____________________________

99 Lightning
94 Cobra-Davidson
74 Vette
Post #: 1
RE: 81 VETTE AND CRATE MOTOR - 3/29/2006 7:08:37 PM   
Lee Willis

 


Posts: 1991
Joined: 7/27/2005
Status: offline
Lee Willis's photo gallery
You have a good plan and should end up with a great car. The ZZ4 is a great motor. There is someone on this forum sometimes (NY MAN, I think) who has one in a restored Chevelle and loves it: performs a bit better than the big block (396) did in the original.

With crate motors, my experience is: 1) subtract 20 HP from the rating to get an equivalent to ratings of engines in cars (e.g, the 350 HP of the 2003 Corvette) - the 355 Hp ZZ4 is equivalent to about 335 HP., 2) When buying GM or name brand crate engines buy the carbs, etc., the builder recommends, if you can buy the entire package (with carbs, etc.) you get a compatible package, 3) realize though that if you put headers on the engine (I would) you may have to rejet the carb a bit to compensate, 4) the engine will produce signifcantly more power than the original so do not abuse the trans and rear end or you will be replacing them soon.

_____________________________

2007 Aston Martin Vantage Prodrive
Lincoln MKZ "Grandfather car"
''98 Z28 with iron LS 408, NOS, tricks, street driven mid 9s (sold to my youngest son for $1, Aug 28, ''07)
''02 SCd 427 cid ZO6, 704 RWHP, sold Aug. 28, ''07

(in reply to Zurok)
Post #: 2
RE: 81 VETTE AND CRATE MOTOR - 3/29/2006 7:33:56 PM   
corvette king




Posts: 1162
Joined: 3/5/2006
From: deltona fl, 32738
Status: offline
corvette king's photo gallery
lee's oppinion was a good one.how mild to wild do you want to go . i had a zz4 in a 73 camaro.it was a very good motor. has steel crank,pm rods . forged pistons.roller cam,and decent heads.i ran a little bigger cam then the one that came with the short block,i ran a edelbrock air gap intake manifold had the heads ported stage 2.a 650 holly vacume secondary carb,roller rockers 1.6..long tube headers [hooker super comp].msd distributor and buz box and blaster 2 coil,the cam was a custom cut cam made for the motor and tranny and gears and stall converter,made power from 2500 to 6500 rpm all day the camaro ran 12.37 on drag radials-.with 373 gears and a 2800 stall converter.that was like 3years ago and the car is still runing at the track the last time i saw it with the same mods and no rebuild., so i would say great choice.

good luck.


Thumbnail Image


Attachment (1)

_____________________________

DRIVE IT LIKE YOU STOLE IT !




(in reply to Zurok)
Post #: 3
RE: 81 VETTE AND CRATE MOTOR - 3/29/2006 9:14:28 PM   
Zurok

 

Posts: 14
Joined: 1/3/2006
Status: offline
Thanks for the input gentlemen. The 81 Vette for $9K is not looking so good. All the picutres the seller sent had rust indicators all over the interior. I think it would probably get worse under the rocker panels, windshield posts, etc. I am intent on getting a C3, preferably an 81, and putting a ZZ4 Crate Motor in it. I'm just looking for a good platform to start with. I will keep looking and if you find a good buy on an 81 Vette, please let me know. I'm looking to spend about $9K for a project car. Looking forward to working with you guys.
Semper Fi

_____________________________

99 Lightning
94 Cobra-Davidson
74 Vette

(in reply to corvette king)
Post #: 4
RE: 81 VETTE AND CRATE MOTOR - 3/29/2006 9:42:21 PM   
corvette king




Posts: 1162
Joined: 3/5/2006
From: deltona fl, 32738
Status: offline
corvette king's photo gallery
well good luck in your findings.hope you score big,were do you live.

_____________________________

DRIVE IT LIKE YOU STOLE IT !




(in reply to Zurok)
Post #: 5
RE: 81 VETTE AND CRATE MOTOR - 3/29/2006 10:05:17 PM   
Zurok

 

Posts: 14
Joined: 1/3/2006
Status: offline
I live in New Baltimore. Mi. just outside of Detroit.

_____________________________

99 Lightning
94 Cobra-Davidson
74 Vette

(in reply to corvette king)
Post #: 6
Login OR Register now to post a reply to this forum topic.
Page:   [1]

 
Corvette >> General >> General Tech
Jump to:


Featured Sponsors
Advertising Info

Top 10 Posters
c3 starship4814
blueshark2180
topspeed2092
lee willis1991
mech2591760
pay2play1533
cwb1508
corvette kin1162
73shark1130
pg1066

New Vendors
AMSOIL - Performance Oil Technology

Corvette Forums .com is not affiliated with or endorsed by Chevrolet Motors Division or General Motors.