tranny movement

Corvette Forums Corvette Classifieds Gallery Corvette News Member List Search Sponsors
Forum FAQ Calendars Contact Us Corvette Recalls TSBs Corvette Timeslips Register Login

tranny movement

Printable Version

Corvette >> General >> General Tech >> tranny movement

Page: [1]

Message

<< Older Topic Newer Topic >>

tranny movement - 6/1/2006 1:03:11 AM

d93vette

Posts: 45
Joined: 5/27/2006
Status: offline

hey guys, looking for anyone who's had a problem like this. I had a new clutch put in, then the transmission started to move 2-3 inches [up] during hard or medium starts. I changed the control rods bushings, same thing. The driveline support beam looks tight too. The only other thing would be the rearend to body bushings. Just want to no if i'm rite or wrong.

Post #: 1

RE: tranny movement - 6/1/2006 7:25:52 AM

mech259

Posts: 1760
Joined: 1/22/2006
From: Lumberton, Texas
Status: offline

Have to make sure that the bolts than attach the channel to the rearend are secure. Rearend bushings, unless they are completely gone, probably not the culprit. You say the support beam "looks" tight, but check with a wrench. It the problem started after the clutch install, then that probably is the culprit.

_____________________________

L.B.
ASE Master Certified
L1 Emissions Certified
1986 C4
1969 RS Z28 Camaro
1970 Chevelle SS 396 (under construction)

(in reply to d93vette)

Post #: 2