Zoomers Exhaust For ZO6
Login | |
|
|
|
|
|
RE: Zoomers Exhaust For ZO6 - 7/24/2006 7:17:57 PM
|
|
|
Aperformance
Posts: 51
Joined: 4/3/2006 Status: offline
|
Photos off the car... Notice how the pipe necks down to 2.5" from 3" going into the mufflers. Thumbnail Image
Thumbnail Image
Thumbnail Image
Thumbnail Image
Thumbnail Image
Attachment (5)
_____________________________
Click link below for video, installation photos and dyno graphs: http://www.zoomersexhaust.com/vehicle_chevrolet_corvette.asp
|
|
|
|
RE: Zoomers Exhaust For ZO6 - 7/24/2006 7:25:33 PM
|
|
|
Aperformance
Posts: 51
Joined: 4/3/2006 Status: offline
|
Photos of the new under panel installed and Factory H-pipe we'll utilize with the axle back version of our new exhaust. Thumbnail Image
Thumbnail Image
Thumbnail Image
Thumbnail Image
Thumbnail Image
Attachment (5)
_____________________________
Click link below for video, installation photos and dyno graphs: http://www.zoomersexhaust.com/vehicle_chevrolet_corvette.asp
|
|
|
|
RE: Zoomers Exhaust For ZO6 - 7/25/2006 10:36:43 AM
|
|
|
PAY2PLAY
Posts: 1533
Joined: 10/2/2005 Status: offline
|
Looking good...I can't wait to hear how she sounds when its all done.
_____________________________
'98 6 Speed Coupe (SOLD Oct. 07) '99 Lexus RX300 (wifes) '02 Lexus GS300 Sport Design (daily driver) [link=http://media.putfile.com/Exhaust-Clip81]Exhaust Sound Clip[/
|
|
|
|
RE: Zoomers Exhaust For ZO6 - 7/25/2006 5:19:33 PM
|
|
|
Aperformance
Posts: 51
Joined: 4/3/2006 Status: offline
|
Here are some pictures of the jig we built for the rear mufflers which will mate up with the stock H-pipe in the first version of our Zoomers Z06 Axle-Back Exhaust. The second version will be a complete cat-back with x-pipe. Thumbnail Image
Thumbnail Image
Thumbnail Image
Thumbnail Image
Attachment (4)
_____________________________
Click link below for video, installation photos and dyno graphs: http://www.zoomersexhaust.com/vehicle_chevrolet_corvette.asp
|
|
|
|
RE: Zoomers Exhaust For ZO6 - 7/26/2006 5:10:57 PM
|
|
|
Aperformance
Posts: 51
Joined: 4/3/2006 Status: offline
|
Keep in mind this is the prototype for the jig and not the final product.... The final product will be tig welded and polished. There is still some tweeking to do to get it perfect, but it's looking good. I heard it today and it sounds awsome. Haven't drove it yet but we'll get in a road test tomorrow to determine if it needs the resonator cans or not. Take a look... Thumbnail Image
Thumbnail Image
Thumbnail Image
Thumbnail Image
Thumbnail Image
Attachment (5)
_____________________________
Click link below for video, installation photos and dyno graphs: http://www.zoomersexhaust.com/vehicle_chevrolet_corvette.asp
|
|
|
|
|