Corvette Forums - Corvette Enthusiast Site - Search Results

Notices
 
Search: Posts Made By: 73shark
Showing results 1 to 25 of 500
Search took 0.26 seconds.
03-07-2019, 08:38 PM
Replies: 1
Views: 100
Posted By 73shark

Welcome to the forum. My 73 courtesy light switch...

Welcome to the forum. My 73 courtesy light switch did not have any rubber around it. Just had the plunger extending through from the housing.
03-01-2019, 07:52 PM
Replies: 3
Views: 1,462
Posted By 73shark

It probably depends on who makes them. But then...

It probably depends on who makes them. But then there's probably not that big a demand for aftermarket door panels of any year and there may only be one or two manufacturers.
03-01-2019, 11:03 AM
Replies: 3
Views: 1,462
Posted By 73shark

Are you referring to a particular aftermarket...

Are you referring to a particular aftermarket supplier or just any reproduction door panels in general? Personally I've heard that Al Knoch has a good reputation.
02-28-2019, 04:33 PM
Replies: 8
Views: 413
Posted By 73shark

Bob: Welcome to the forum. Assuming you have a...

Bob: Welcome to the forum. Assuming you have a square bore manifold, I would go ahead and put a Holly or other brand four barrel back on it. If the rear rotors still have the rivets holding them on,...
02-25-2019, 01:24 AM
Replies: 10
Views: 292
Posted By 73shark

If you post this in the C4 section, you'll get...

If you post this in the C4 section, you'll get more views.
02-19-2019, 01:27 PM
Replies: 10
Views: 292
Posted By 73shark

One reason converting R12 to R134a which is less...

One reason converting R12 to R134a which is less than satisfactory is because R134a needed to operate at a higher pressure and required a larger condenser and a more efficient evaporator. Even some...
02-18-2019, 08:44 PM
Replies: 10
Views: 292
Posted By 73shark

That's an interesting piece of information. Where...

That's an interesting piece of information. Where did you come across that?

Good luck in your search.
02-17-2019, 02:31 PM
Replies: 10
Views: 292
Posted By 73shark

Welcome to the forum. One thing that I know about...

Welcome to the forum. One thing that I know about the C4s is that the Optispark which is situated right below the water pump is susceptible to water damage especially when the water pump starts to...
02-11-2019, 11:58 AM
Replies: 3
Views: 276
Posted By 73shark

Welcome to the forum. That sounds like the float...

Welcome to the forum. That sounds like the float level might be set too high and the throttle shaft bores need to be bushed.
02-10-2019, 06:39 PM
Replies: 5
Views: 288
Posted By 73shark

Didn't realize that it was a SBC. Can imagine if...

Didn't realize that it was a SBC. Can imagine if the bore centers are the same as a regular small block how thin the cylinder walls will be. Good luck with your project.
02-09-2019, 01:00 PM
Replies: 5
Views: 288
Posted By 73shark

I don't know how much the differential can stand...

I don't know how much the differential can stand or whether it was different for BBC early on but I do know that the half shafts and U joints were different for the BBC. Another consideration is...
02-09-2019, 11:07 AM
Replies: 5
Views: 288
Posted By 73shark

Well I don't doubt that you can put that big...

Well I don't doubt that you can put that big engine in a late C3, it will be a very expensive project. Just a set of exhaust manifolds is very expensive. Of course if you go with headers, you...
02-08-2019, 10:13 AM
Replies: 1
Views: 109
Posted By 73shark

Welcome to the forum. Isn't the only thing...

Welcome to the forum. Isn't the only thing different with the NPP dual mode exhaust the addition of the actuators? Have you contacted them to see why they think it won't fit on your car?
Forum: General Tech
02-08-2019, 10:06 AM
Replies: 2
Views: 276
Posted By 73shark

Welcome to the forum. To be safe, you might...

Welcome to the forum. To be safe, you might consider upgrading the bottom end as I don't know how stout that engine is when normally aspirated. You also might need a taller hood. Have you considered...
02-05-2019, 06:04 PM
Replies: 3
Views: 226
Posted By 73shark

Welcome to the forum. Be sure to visit the C7...

Welcome to the forum. Be sure to visit the C7 section of the forum.
02-02-2019, 09:36 AM
Replies: 1
Views: 287
Posted By 73shark

Tire Rack is a good place to start online.

Tire Rack is a good place to start online.
01-31-2019, 12:01 PM
Replies: 1
Views: 174
Posted By 73shark

Welcome to the forum. You need to post your...

Welcome to the forum. You need to post your question in the C6 section so people can see it. This is the new member welcome area only. Although I'm not familiar with the C6 body structure, that...
01-27-2019, 12:22 PM
Replies: 4
Views: 262
Posted By 73shark

You might you might try places like Corvette...

You might you might try places like Corvette Central and Wilcox.
01-27-2019, 11:51 AM
Replies: 4
Views: 262
Posted By 73shark

Welcome to the forum. I remember reading where...

Welcome to the forum. I remember reading where people have taken a C4 blower motor and used it in a C3 to increase the flow. But in order to do so they had to add the three quarter inch spacer that...
01-26-2019, 12:12 PM
Replies: 1
Views: 256
Posted By 73shark

Welcome to the forum. It could be something as...

Welcome to the forum. It could be something as simple as a faulty connection somewhere, bad ground, or an intermittent sensor. Intermittent problems like this are always tough to diagnose. You might...
01-26-2019, 11:43 AM
Replies: 1
Views: 334
Posted By 73shark

Welcome to the forum. I tend to lean toward Al...

Welcome to the forum. I tend to lean toward Al Knoch for interior pieces. Other suppliers are out there and quite honestly they may all get their material from the same manufacturer. Doesn't hurt to...
01-23-2019, 01:23 PM
Replies: 1
Views: 144
Posted By 73shark

Welcome to the forum. You need to post your...

Welcome to the forum. You need to post your question in the C4 area of the Forum as this is just a welcome new members area. You will get a lot more views that way. Some of the aftermarket suppliers...
Forum: General Tech
01-22-2019, 05:09 PM
Replies: 6
Views: 553
Posted By 73shark

Thanks Dale for the info. Hopefully GM will do...

Thanks Dale for the info. Hopefully GM will do the right thing and take care of this problem.
Forum: General Tech
01-20-2019, 04:22 PM
Replies: 1
Views: 147
Posted By 73shark

Welcome to the forum. Some of the aftermarket...

Welcome to the forum. Some of the aftermarket suppliers sell wiring diagrams.
01-18-2019, 04:29 PM
Replies: 3
Views: 397
Posted By 73shark

Haven't heard of them but have you tried...

Haven't heard of them but have you tried contacting them?
Showing results 1 to 25 of 500
 


 
Forum Jump

Advertising
Featured Sponsors
Vendor Directory

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.