Rickcusaf
07-01-2009, 07:48 PM
I've got to replace one of mine and I'm trying to find out the torque specs for the roller-rocker and figure out why I've got such an odd setup.
From what I can tell my push rods should be 7.9", but all of mine are 5/16 .83 7.2. I can't seem to find any information on this and could use some help!
-Rick
*edit*
I found the reason! *Drumroll* at some point the stock engine seems to have been replaced with an LT1 variant.
From what I can tell my push rods should be 7.9", but all of mine are 5/16 .83 7.2. I can't seem to find any information on this and could use some help!
-Rick
*edit*
I found the reason! *Drumroll* at some point the stock engine seems to have been replaced with an LT1 variant.