Corvette C3 Forum 1968 through 1982

door hinges f/ '81 C3

Thread Tools
 
Search this Thread
 
  #1  
Old 07-03-2010, 06:33 PM
Texas Jim's Avatar
Senior Member
Thread Starter
Join Date: Dec 2005
Location: Killeen, Texas
Posts: 527
Default door hinges f/ '81 C3

Need upper and lower driver side door hinges f/ my '81 'Vette. Looked in Mid America Motors and they want $139.00 a piece f/ them plus a $40.00 core charge. Does anyone know of any other parts place that has them any cheaper? Thanks in advance f/ any input.
 
  #2  
Old 07-08-2010, 08:59 PM
Palmbeachvette's Avatar
Junior Member
Join Date: Apr 2010
Posts: 7
Default

What is the reason for the need for the hinges? Is the door sagging or out of alignment? Reason I ask is I thought I needed new hinges on my 76 until I saw the prices and decided to replace the pins and bushings instead since I could lift the door upward when it was open and saw the play in the inner and outer hinge plates. Replacing the pins and bushings cured everything for a fraction of the cost and I did the job myself.
 
  #3  
Old 07-25-2010, 05:51 PM
Texas Jim's Avatar
Senior Member
Thread Starter
Join Date: Dec 2005
Location: Killeen, Texas
Posts: 527
Default

I wish it was the bushing and pin. I backed out of the driveway w/ the driver door open and caught the fence. It pushed the door backward and cracked both hinges. Yea, what a mishap. The car is quite flawless, and now I have freakin' 2 cracks at the end of the door along w/ a small piece about a half inch square out of the rear of the front fender. I need to go get intouch with my buddy who has a shop and take care of it there. Made me sick when it happened.
Thanks f/ the reply.
I think I'll take the hinges off, put them in a vice, get them in right positon to weld them up. Won't be hard, as they're not twisted at all, just the small crack in each.
 

Last edited by Texas Jim; 07-25-2010 at 05:54 PM.
  #4  
Old 08-18-2010, 11:19 PM
davebearpig's Avatar
Junior Member
Join Date: Aug 2010
Posts: 1
Default

I haven't ever worked on a car body, but I have done a lot of welding. If you can get the hinges in a vice like you said, I would put a little bit of heat to them, get the aligned the way you want them, weld it up very nicely and grind it down flush.

Repaint, reattach, and then spend all of that money you would have spent on something else.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
crashbug
Parts/Other Sales
0
09-05-2008 11:07 AM
HIMTIM
General Tech
1
10-09-2005 12:26 AM
gwgarage
Parts/Other Sales
0
08-25-2005 07:32 PM
VETTELOVER
Corvette C3 Forum
2
07-31-2005 11:44 PM
E.G. 1
New Member Area
1
07-22-2005 01:30 PM



Quick Reply: door hinges f/ '81 C3



All times are GMT -5. The time now is 10:13 AM.