General Tech Good at troubleshooting? Have a non specific issue? Discuss general tech topics here.

1989 vette MAF schematic

Thread Tools
 
Search this Thread
 
Old Nov 14, 2008 | 05:48 PM
  #1  
TX Mike's Avatar
Thread Starter
Joined: Nov 2008
Posts: 42
Default 1989 vette MAF schematic

Anyone know best place to get a fuel injection manual for '89 vette? Any help is greatly appreciated. Thanks so much for your time!!

Mike
 
Old Dec 6, 2008 | 12:36 AM
  #2  
TX Mike's Avatar
Thread Starter
Joined: Nov 2008
Posts: 42
Default RE: 1989 vette MAF schematic

Finally, autozone sold me a bad ECM. Vette back on the road and running. Thanks so much for all your help!!

Mike
 
Old Dec 6, 2008 | 06:19 PM
  #3  
TX Mike's Avatar
Thread Starter
Joined: Nov 2008
Posts: 42
Default RE: I spoke to soon

I put new ECM in and it ran good while driving it around for about 30 minutes. The next morning after running it for about 10 minutes it went back to the same problem: When I give it gas it dies!

I believe it got a power surge of some kind to the ECM (probably damaging it again). Any suggestions is appreciated!! Thanks!

MIke
 
Old Dec 7, 2008 | 05:22 AM
  #4  
TX Mike's Avatar
Thread Starter
Joined: Nov 2008
Posts: 42
Default RE: not fixed yet

I put new ECM in and it ran good while driving it around for about 30 minutes. The next morning after running it for about 10 minutes it went back to the same problem: When I give it gas it dies!

I believe new ECM gone again. Poor pulse again. Any suggestions is appreciated!! Thanks!

Mike
 
Old Dec 11, 2008 | 05:06 PM
  #5  
DeeVeeEight's Avatar
Banned
Joined: Oct 2007
Posts: 594
From: South Jersey
Default RE: not fixed yet

[sm=headbang.gif][sm=headbang.gif][sm=headbang.gif][sm=icon_beat.gif][sm=icon_rtfm.gif]
 
Old Dec 21, 2008 | 02:54 PM
  #6  
TX Mike's Avatar
Thread Starter
Joined: Nov 2008
Posts: 42
Default RE: running

Thanks everyone for your help. Also, thanks to Jon at FIC for the bosch injectors. So for so good. Car running great.

Mike
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
corv1989
General Tech
4
Jul 9, 2011 10:35 PM
TX Mike
Corvette C4 Forum
2
Nov 16, 2008 10:21 AM
TX Mike
Technical Diagram Help
0
Nov 14, 2008 05:47 PM
cyclic hardover
Corvette C3 Forum
1
Sep 22, 2007 09:15 PM
1974corvetteowner
General Tech
2
Aug 25, 2005 03:33 PM




All times are GMT -5. The time now is 09:51 AM.