Help!!
#1
Help!!
Alright, i really could use some help here, my 95's clutch seems to have just gone, i was driving to get lunch when i felt the pedal get real easy to push in, i turn back around and by the time i got home, there was no resistance to the pedal and the clutch would not disengage, so i cannot go into any gears now. Is there an adjustment on the pedal, or near the transmission that i can get to, or do i need to replace the clutch????
#7
RE: Help!!
If the fluid level gets too low, it could possibly have pulled in some air into the system, which would cause you to have no clutch petal. If it is low on fluid, then you may have a leak somewhere.
Did you see any leaks under the car?
If you have sufficient fluid in the master cylinder, the seals in the master cylinder itself, or the seals in the slave cylinder on the transmission could have gone bad.
Did you see any leaks under the car?
If you have sufficient fluid in the master cylinder, the seals in the master cylinder itself, or the seals in the slave cylinder on the transmission could have gone bad.
#10
RE: Help!!
sounds like slave cylinder is the issue. rebuild kits are cheap enough, they consist of a new plunger. no point in buying the whole slave cylinder. remove slave ,replace plunger, put back on car , bleed the line and you should be good to go, make sure to keep full of brake fluid while bleeding air out. hope that helps