Hi everyone,

Actually, it is my son who owns the Corvette. I, however, am an amatuer carver and hope to carve a small wooden replica of his car as a surprise. I have found pictures of the car online but no dimensions (length, width, height). Consequently, the pattern I have workedup looks out of kilter. I would appreciate any help anyone can give me. Thanks.

Hello Liza Her is some info for you. Hope this helps



Wheelbase
104.5/2655.5

Length (overall)
179.7/4565.6

Width (overall)
73.6/1869.6

Height (overall)
47.7/1211.5 (hardtop and coupe), 47.8/1214.7 (convertible)

Hello watwheel,

Thank you for the info. If my carving project turns out even half as well as I hope, my son and I will both have you to thank. I really do appreciate your help

liza65

Hey Mary, you are very welcome! If your project turns out to your satisfaction, post a picture on this forum. You might be able to make and sell a few of them right here. I would be interested. Keep us posted. Thanks
Mike

Mike, thanks for the vote of confidence! However, please keep in mind that the operative phrase here is AMATUER CARVER! I do promise, though, that if the end result is anywhere near presentable, I will indeed post a picture of my work. Thanks again.
Mary

Me too, me too,....[sm=bounceybounce.gif]!
I wanna see.....;)

And yes, Welcome to CFs. :)