C5 Switchback LED resistor mounting??
#1
C5 Switchback LED resistor mounting??
Has anyone come up with a creative way to mount the resistors that correct for hyperflashing caused by the switchback bulbs? I tried wire ties, and it melted the tie! The things just get way to hot. Any guidance is appreciated-
Corey
Corey
#2
Try using GE 162 silicone (max temp = 400F):
You can get it at www.mcmaster.com
It comes in a 2.8 oz tube, cost about $19, and is their part number:
74935A45
162 Noncorrosive—Noncorrosive to copper and brass. Bonds capacitors, resistors, and integrated circuits to printed circuit boards. Also insulates exposed copper wires and terminals. Begins to harden in 4 hours; reaches full strength in 48 hours. Meets MIL-A-46146B. UL recognized.
It comes in a 2.8 oz tube, cost about $19, and is their part number:
74935A45
Thread
Thread Starter
Forum
Replies
Last Post
c5, c6, corvette, diagram, hyperflashers, install, integrated, led, mods, resistor, resistors, site, switchback, switchbacks, wiring, z06