1982 CE C3 randomly not starting.
Thread Starter
|
Member
Joined: Mar 2022
Posts: 36
From: SoCal
The old junction block that wasn't in too bad of shape. By adding a new one I cleared the free shipping on my online order.
The old ECM plug for the inline fuse.
Old fuse
Purchased another inline fuse. I soldered the wires and used heatshrink. Again this is heading to the ECM.
Last edited by Bellworx; Jun 20, 2022 at 07:23 AM.
Thread Starter
|
Member
Joined: Mar 2022
Posts: 36
From: SoCal
Cleaned up some of the other wires. Crimped, soldered and heatshrink.
New junction block. The large wire on the right I only crimped it and added solder. I didn't have a connector that would fit it.
Thread Starter
|
Member
Joined: Mar 2022
Posts: 36
From: SoCal
Not perfect but not bad. Starts right up everytime so far now. I need a battery hold down setup. The quick disconnect is a tight fit and I read about a different setup most use. For now I'll leave it on.
Thread
Thread Starter
Forum
Replies
Last Post
